IDROMAT 5-30 - Electronic Regulator for Pumps

IDROMAT 5-30

Construction

Regulation device for pump control equipped with flow and pressure sensor connected to an electronic system.
Inlet and delivery connection ports of the same diameter.
Built-in check valve. Pressure gauge 0-12 bar supplied as standard for IDROMAT 5.. (IDROMAT 6.. not present).
Automatic reset function  for the reset of the system without manual operation.

Applications

utomatic control of pumps for water supply and increase of network pressure.
Control of starting/stopping of the pump when cocks are opened/closed.

For protection of the pump:

– against dry running; – against the risk of operation without water at the inlet
(caused by a lack of water inflow in the inlet pipe under positive suction head,
by a non-immersed suction pipe, by excessive suctionlift or by air entering the suction pipe);
– against operation with closed connection ports.

Operating conditions

Mains voltage: single-phase 230 V ±10% Idromat 5e; single-phase 115 - 240 V ±5% for Idromat 5, 6.
Frequency: 50 - 60 Hz. Current values: -   8A max during operation (16A max at start-up) for IDROMAT 5; - 16A max during operation (30A max at start-up) for IDROMAT 6 Maximum pump motor power 1,5 kW (2,2 kW for IDROMAT 6).
Protection: IP 65. Maximum working pressure: 12 bar (1,2 MPa) Maximum
Operating temperature up to 65 °C. Minimum flow ~ 1 l/min. Male connections 1” (1 1/4 for IDROMAT 6).

Electronic regulator for pumps